ChristmasCave Downloads

The files available for download from this site have been compressed to speed file transfer times. Once downloaded, you will need to decompress (unzip) these files using software such as WinZip.

Select one of the following:

Demo Software

DasherDEMO v2.0 (4.42 MB)

The latest demo release of Dasher.  This demo does everything the full version of Dasher v2.0 will do except save grid files and control lights and/or other devices attached to the computer.  Designed for Windows 9x/NT4 or later.

SACB Programmer Demo v1.0 (2.60 MB)

A demo of the utility used to program Stand Alone Control Boxes (SACB's).  Designed for Windows 9x/NT4 or later.

Test Communications utilities

Digital Test Communications Program v2.0 (3.73 MB)

Program that tests your computer's communication with and control of digital I/O cards installed in your computer.  Designed for Windows 9x/NT4 or later.

FireCracker Test Communications Program v2.01 (1.44 MB)

Program that tests your computer's communication with and control of an X10 CM17A (FireCracker) computer interface module.  It allows for multiple commands to happen with one click.  This is handy for figuring out how much time a given series of commands takes to complete.  Designed for Windows 9x/NT4 or later.  Requires a CM17A (FireCracker) X10 module and associated transceiver hardware.

Parallel Test Communications Program v2.0 (3.38 MB)

Program that tests your computer's communication with and control of the parallel port(s) installed in your computer.  Designed for Windows 9x or later.  This software will not work on Windows NT.

Serial Test Communications Program v2.01 (3.37 MB)

Program that tests your computer's communication with and control of Serially-Controlled Control Boxes (SCCB's).  Designed for Windows 9x/NT4 or later.

X10 Test Communications Program v2.01 (1.46 MB)

Program that tests your computer's communication with and control of an X10 CM11A computer interface module.  It allows for multiple commands to happen with one click.  This is handy for figuring out how much time a given series of commands takes to complete.  Designed for Windows 9x/NT4 or later.  Requires a CM11A X10 module and associated serial cable.

Miscellaneous Software

SCCB Addresser utility v1.0 (3.37 MB)

Program that allows you to change the address of serially-controlled control boxes (SCCB's) that contain the SCCB v2.0 chip.  You can change the addresses of many different boxes to the same address all at once or individually address and change single boxes without having to disconnect them.